Denttach is a thermoplastic denture adhesive which adheres through a "suction effect". It’s unlike your regular denture adhesive which adheres through glue.

Denttach works also as a cushion for your dentures by filling in the gaps  between your gums and dentures and creating a comfortable cushion in between.

Denttach is created using proprietary ingredients and formula.This magic happens in a small laboratory in small batches to create this product, as opposed to regular denture adhesives which are mass produced as a glue. Also one tube lasts 4 - 6 weeks so in the long run its actually less costly then regular denture adhesives. 

Yes, Denttach can be used safely on all types of upper, lower and partial dentures.

Yes, you should continue to brush and clean your denture as you would normally do. Denttach is 100% waterproof and will not wash off with water  like regular denture adhesives.

Denttach is non-toxic  does not contain zinc. However, please keep out of reach of children.

Denttach  lasts a full seven days. We recommend removing and reapplying every 7 days for optimal results.

It really depends on  how much Denttach is used during each application, a 20 g tube should last 4-6 weeks depending on whether they are using on both upper and lower denture, one denture, or a partial.

There should be no need to use regular adhesives with Denttach, but you can.

A temporary slight stinging or burning sensation may be experienced with the first application, but should last no more than a few moments.

Denttach should be stored  at room temperature and does not expire.Always keep the cap on tightly to prevent Denttach from hardening .

Denttach is heat activated, please make sure your  following the instructions for use by warming the tube in hot tap water for 5 minutes with cap face down into the water.

Poly Vinyl Acetate, Ethanol, Water,Propanone, Isopropyl, Eucalyptol, Menthol (natural), Pigment Red